Assembly Instructions

Your DIY Tulip Mirror Cube Night Light arrives as a kit. Follow the simple steps below to assemble your own glowing centerpiece in just a few minutes.

Step 1 — Prepare the LED String Lights

  • Untangle the string. Gently separate the LED string so every bulb is free and the wire lies straight.
  • Fit a tulip casing on each bulb. Slide one LED bulb into each tulip cap, then twist the base to lock it in place. Adjust the spacing along the wire as you go, and repeat for every bulb.

Step 2 — Peel the Mirror Panels

  • Remove the protective film. Peel the film off every mirror panel so you get a clean, fully reflective surface.

Step 3 — Attach the Lights to the Base

  • Pick one panel as the base. Lay a single mirror flat on your work surface — this becomes the floor of the cube.
  • Glue the lights down. Using a hot glue gun, fix the tulip lights onto the base, spacing the bulbs evenly. Keep the battery switch sitting just outside the edge so it stays easy to reach.

Step 4 — Add the Decorative Touches

  • Arrange leaves and gems. Position the leaves and gems around the lights on the base, then secure them with a small dab of hot glue. Use glue sparingly to keep the mirror clean.

Step 5 — Build the Cube

  • Fit the corner connectors. Use the double-sided tape to attach the plastic corner edges along the sides of the base panel.
  • Stand up the side mirrors. Press the remaining panels upright into the corner connectors, pushing each edge firmly into place for a snug, seamless fit.

Step 6 — Light It Up

  • Pull the battery tab. Remove the safety tab from the battery switch to power the lights.
  • Enjoy the glow. Switch on your night light and watch the infinity-mirror reflections fill the cube with color.

Tips & Tricks

  • Handle with care. Mirror edges can be sharp — take your time, and be cautious if you use a lighter or hot glue gun.
  • Make it yours. Swap in different flowers, colors, or accents to give your cube a personal touch.
  • Keep it clear. Wipe the mirrors with a soft, dry cloth to remove dust and fingerprints for the best reflective effect.

That’s it — your one-of-a-kind Tulip Mirror Cube Night Light is ready to shine. Enjoy your creation!